A quick, 5-minute read to keep your timepiece ticking for decades.
1. Skipping the Post-Swim Rinse
❌ Mistake: Assuming “water-resistant” means “chlorine-proof.”
⚙️ Fix: After every swim—pool or ocean—rinse under cool tap water, pat dry, then air-dry crown-down. Salt and chemicals eat gaskets fast.
2. Setting the Date Between 9 p.m. – 3 a.m.
❌ Mistake: Adjusting the date while the date-change gears are engaged.
⚙️ Fix: Pull the crown to time-setting, move hands past 3 a.m., then set the date. Zero stripped gears, zero drama.
3. Over-Winding Manuals & Under-Winding Autos
❌ Mistake: Cranking a manual until it squeaks—or never giving an automatic its 30–40 crown turns after downtime.
⚙️ Fix: Stop winding manuals the moment you feel resistance. For autos at rest, give 30 smooth crown turns before wearing.
4. Ignoring Yearly Pressure Tests on “Water-Resistant” Quartz
❌ Mistake: Believing quartz gaskets last forever.
⚙️ Fix: Pressure-test every 12–18 months if you shower or swim with it. A $30 test beats a $300 movement swap.
5. Leaving Crowns or Pushers Un-Screwed
❌ Mistake: Forgetting to screw-down the crown, or pressing chrono buttons underwater.
⚙️ Fix: Ritualize it—wind, set, screw-down. Keep hands off pushers unless the watch is clearly rated for it (200 m+).
6. Storing on a Hot Dashboard or in Direct Sun
❌ Mistake: Heat bakes lubricants and fades dials.
⚙️ Fix: Use a shaded drawer or travel roll. In a car, glovebox > dashboard.
7. Magnetizing Your Movement
❌ Mistake: Parking the watch near laptop speakers, phone mags, or magnetic bag clasps.
⚙️ Fix: Keep watches 15 cm / 6 in away. Second hand stuttering? A $20 demagnetizer fixes it in 10 sec.
8. DIY Strap Changes Without Tape or a Spring-Bar Tool
❌ Mistake: Prying with a knife and scarring the lugs.
⚙️ Fix: Spend $10 on a spring-bar tool and cover lugs with painter’s tape. Two minutes of prep = zero resale-killing scratches.
9. Letting Automatics Sit Dead for Weeks
❌ Mistake: Repeatedly draining the power reserve to zero.
⚙️ Fix: If unworn > 3 weeks, give a full wind monthly or use a low-TPD winder. Lubes stay fluid; accuracy stays tight.
10. Skipping the 5-Year Full Service
❌ Mistake: Waiting until the watch runs slow—or stops.
⚙️ Fix: Budget an overhaul every 4–6 years (clean, oil, regulate, new seals). Cheaper than replacing a worn escapement later.
Quick-Reference Cheat Sheet
| ✅ Do This | 🚫 For Avoiding This |
|---|---|
| Rinse after swimming | Chlorine / salt buildup |
| Wind manuals until resistance | Over-cranking |
| Set date outside 9 p.m.–3 a.m. | Stripping date gears |
| Tape lugs before strap swaps | Lug scratches |
| Pressure-test yearly if you swim | Silent gasket failure |
Final Thoughts
Mechanical or quartz, a wristwatch is a miniature machine enduring 100+ million vibrations a day. Respect the tolerances, and it will outlive you; abuse them, and it becomes a paperweight. Follow the checklist above, and you’ll spend more time enjoying your watch than explaining repair invoices.
🚀 Keep Learning
- Subscribe to Mechanical Minutes for deep dives into calibres and affordable watch picks.
- Got a horror story? Share your biggest maintenance mistake in the comments—help the next enthusiast avoid it!
Stay ticking!
Mechanical Minutes 